C204: (Servo motor encoder connector is not in good contact)
C601:
C602: Return to zero fault.
(It can be solved by writing the value displayed by S-0-0288 to S-0-0289)
E257: The DC limit function is working. The drive is overloaded.
E410: Cannot follow or scan 0# address.
F219: The motor is shut down due to overheating.
F220: The load potential energy exceeds the absorption capacity of the servo drive.
F228: Excessive deviation.
F237: The set position or speed value exceeds the maximum value allowed by the system (servo drive).
F434: Emergency stop. The emergency stop function of the servo drive is activated.
F822: The encoder signal of the servo motor is absent or too small.
F878: Speed loop error.
F2820 = F220: Braking resistor is overloaded.
Post time: Sep-16-2021
